The zeolite runner device is essentially a concentrator. The waste gas containing organic solvent after treatment by the runner is divided into two parts: clean air that can be discharged directly and regeneration air containing high concentration organic solvent. Powdered activated carbon Zhejiang The clean air that can be directly discharged can enter the spray paint air conditioning ventilation system for recycling; The concentration of high concentration VOCs is about 10 times that of the VOCs before entering the system. The concentrated gas is then incinerated at high temperature through the TNV recovery thermal incineration system (or other equipment). The heat generated by incineration is respectively used to heat the drying room and the zeolite wheel desorption. The heat is fully used to achieve the effect of energy conservation and emission reduction. Technical performance and characteristics: simple structure, convenient maintenance and long service life; High absorption and desorption efficiency, so that VOCss waste gas with high air volume and low concentration can be converted into low air volume and high concentration waste gas, reducing the cost of back-end final treatment equipment; The pressure drop generated by the adsorption of VOCs by the zeolite runner is extremely low, which can greatly reduce the power consumption; The overall system adopts pre assembly and modular design, which has a small space requirement and provides a continuous and unmanned control mode; Waste gas concentrated by runner, Powdered activated carbon manufactor It can meet the national emission standards; The adsorbent uses non combustible hydrophobic zeolite, which is safer to use; The disadvantage is that the one-time investment is high.

Powdered activated carbon major The addition of retention aids in the wet end of paper making is an important way to improve filler retention, which has been widely used in industrial production. Some studies reported that clinoptilolite (particle size 0.5-2 μ m) was used as a microparticle retention aid to compare the retention effect with silica and bentonite microparticle retention aid systems. The retention effect of clinoptilolite retention aid is equivalent to that of the silica microparticle retention aid system with the same dosage, which is far better than that of the bentonite microparticle retention aid system. And the use of zeolite as paper filler eliminates the need for additional microparticle retention aids. It is also reported that the retention rate of TiO2 nanoparticles can be significantly improved by using zeolite molecular sieves as retention aids in the preparation of photocatalytic paper. Compared with starch and cationic polymer, zeolite molecular sieve microparticle retention aids have better effects on improving the retention and drainage properties of paper stock and improving the uniformity of paper. Powdered activated carbon major The use of zeolite particle retention aids can effectively avoid flocculation between fibers, and help to form fiber particle fiber flocculating particles. In addition, it can also support titanium dioxide nanoparticles.

Powdered activated carbon major Rely on its own unique void structure. The pore size of zeolite is uniform, the internal void structure is developed, the specific surface area is large, the adsorption capacity is strong, and contains a large number of invisible pore sizes. The pore size in 1g zeolite material can be expanded to the specific surface area of 500-1000m2, which is higher for special purposes. The mutual adsorption between molecules is also called "van der Waals gravity". Although molecular motion speed is affected by temperature, material and other factors, Powdered activated carbon manufactor But it always keeps moving in the micro environment. Due to the mutual attraction force between molecules, when a molecule is trapped in the inner pore volume of zeolite, it will lead to more molecules being absorbed until the adsorption of zeolite is saturated.

Because there are uniform small internal pores in the molecular sieve structure, Powdered activated carbon Zhejiang When the molecular linear degree of reactants and products is close to the pore size of the crystal, the selectivity of catalytic reaction often depends on the corresponding size of the molecule and pore size. This selectivity is called shape selective catalysis. There are two mechanisms leading to shape selectivity. One is caused by the difference of diffusion coefficient of molecules participating in the reaction in the pore cavity, which is called mass transfer selectivity; The other is caused by the space limitation of the transition state of the catalytic reaction, which is called transition state selectivity. Molecular sieve has clear pore cavity distribution, extremely high internal surface area (600m2/s), good thermal stability (1000 ℃), and adjustable acid site center. The acidity of molecular sieve mainly comes from three coordinated aluminum atoms and aluminum ions (AlO)+on the framework and in the pores. The OH based acid sensitive site center on the molecular sieve HY obtained by ion exchange, and the aluminum ion outside the framework will strengthen the acid site, forming the L acid site center. Polyvalent cations such as Ca2+, Mg2+and La3+can show the acid site center after exchange. The reduction of transition metal ions such as Cu2+and Ag+can also form acid site centers. In general, the higher the Al/Si ratio, the higher the specific activity of OH group. The modification of zeolite acidity can introduce protons through direct exchange of dilute hydrochloric acid. Powdered activated carbon major This method often leads to dealumination of molecular sieve framework. So NaY will become NH4Y and then HY.

Zeolite molecular sieves have the following potential applications. Powdered activated carbon manufactor (1) Due to the high whiteness of molecular sieves, the optical properties of paper can be improved. (2) It can improve the loose thickness and printability of the paper. (3) Molecular sieves can be used to prepare special papers such as gas filter paper, rust proof paper and photocatalysis paper due to their open structure. (4) It can be used for low weight newsprint and book paper, and can effectively avoid ink penetration. (5) Its ion exchange performance can avoid resin and filler deposition. Powdered activated carbon major (6) It can be used for phenolic paper laminate to improve its corrosion resistance in humid environment. Phenolic paper laminates used as insulators in printed circuit boards and integrated circuits will be affected by electrolytic corrosion when exposed to high humidity. (7) It is mixed with titanium dioxide (TiO2) filler to produce high-quality white paper.