Wood activated carbon high quality The evaluation of the adsorption of zeolite depends not only on whether the specific surface area of zeolite is large enough, but also on whether the equipment is hydrophobic. When purchasing, people can choose the inspection equipment. When the air humidity for the hydrophobicity of the inspection equipment is greater than 60%, if the equipment is blocked and the machine works abnormally, people should carefully consider whether to purchase the equipment. It is important to know that the adsorption and hydrophobicity of the zeolite runner are equally important. The zeolite content of the zeolite runner is proportional to the adsorption concentration efficiency. Therefore, many people should pay more attention to whether the zeolite content of the equipment meets the requirements or is high enough when choosing to purchase the zeolite runner. On the one hand, selecting excellent equipment is also to enhance the potential value of the enterprise. Wood activated carbon Zhejiang The adsorption and concentration technology of zeolite runner is deeply loved by enterprises because of its high efficiency and energy saving characteristics. Its changeable working environment and low cost have laid an unshakable position for zeolite runner in industry. How to select a zeolite runner with stable operation and high efficiency needs people's eyes
The zeolite runner device is essentially a concentrator. The waste gas containing organic solvent after treatment by the runner is divided into two parts: clean air that can be discharged directly and regeneration air containing high concentration organic solvent. Wood activated carbon Zhejiang The clean air that can be directly discharged can enter the spray paint air conditioning ventilation system for recycling; The concentration of high concentration VOCs is about 10 times that of the VOCs before entering the system. The concentrated gas is then incinerated at high temperature through the TNV recovery thermal incineration system (or other equipment). The heat generated by incineration is respectively used to heat the drying room and the zeolite wheel desorption. The heat is fully used to achieve the effect of energy conservation and emission reduction. Technical performance and characteristics: simple structure, convenient maintenance and long service life; High absorption and desorption efficiency, so that VOCss waste gas with high air volume and low concentration can be converted into low air volume and high concentration waste gas, reducing the cost of back-end final treatment equipment; The pressure drop generated by the adsorption of VOCs by the zeolite runner is extremely low, which can greatly reduce the power consumption; The overall system adopts pre assembly and modular design, which has a small space requirement and provides a continuous and unmanned control mode; Waste gas concentrated by runner, Wood activated carbon manufactor It can meet the national emission standards; The adsorbent uses non combustible hydrophobic zeolite, which is safer to use; The disadvantage is that the one-time investment is high.
Wood activated carbon manufactor Microporous molecular sieves with molecular pore size below 2 nm and mesoporous molecular sieves with molecular pore size between 2-50 nm (50 nm The above are macroporous molecular sieves), mesoporous molecular sieves have high specific surface area, regular and orderly pore structure, narrow pore size distribution, continuous and adjustable pore size and other characteristics, which make it play an important role in the adsorption, separation and catalytic reaction of macromolecules that are difficult for many microporous molecular sieves to complete. Therefore, molecular sieve materials with different properties and pore sizes shall be configured according to the different components of organic waste gas during selection, so as to achieve targeted organic waste gas treatment, meet the design requirements and emission standards. The main material of honeycomb zeolite adsorbent is natural zeolite. The manufacturer of zeolite is composed of silica Inorganic microporous material composed of al_2o_3 and alkaline metal or alkaline earth metal, with inner pore volume accounting for 40-50% of the total volume and specific surface area of 100-500 m2/g, is characterized by high temperature resistance, non flammability, good thermal stability and hydrothermal stability. It is an efficient molecular sieve carrier with good adsorption performance, no secondary pollution, and can be regenerated at high temperature. Compared with honeycomb activated carbon, its performance is about 25% of its efficiency, However, it is widely used in the fields of adsorption, separation, catalysis and environment due to its high temperature resistance and difficult ignition, Wood activated carbon high quality It is more suitable for the treatment of organic waste gas with large air volume and low concentration.
The main components of zeolite are: silicon and aluminum, which have adsorption capacity and can be used as adsorbent; Zeolite runner is to use the specific pore size of zeolite to have the ability of adsorption and desorption for organic pollutants, so that VOCs waste gas with low concentration and large air volume can be concentrated and converted into low air volume and high concentration gas by the zeolite runner, which can reduce the operating cost of the back-end final treatment equipment. Wood activated carbon Zhejiang The characteristics of the device are suitable for treating waste gas with large flow, low concentration and various organic components. The disadvantage is high initial investment. The zeolite wheel adsorption purification device is a gas purification device that can continuously perform adsorption and desorption operations. The two sides of the zeolite runner are divided into three areas by special sealing devices: adsorption area, desorption (regeneration) area and cooling area. Wood activated carbon high quality The working process of the system is as follows: the zeolite runner rotates continuously at a low speed and circulates through the adsorption area, desorption (regeneration) area and cooling area; When the exhaust gas with low concentration and large air volume continuously passes through the adsorption area of the runner, VOCs in the exhaust gas are adsorbed by the zeolite of the runner, and the gas purified by adsorption is directly discharged; The organic solvent adsorbed by the wheel is sent to the desorption (regeneration) area with the rotation of the runner, and then the small amount of hot air continuously passes through the desorption area. The VOCs adsorbed on the runner are thermally desorbed in the desorption area to achieve regeneration, and the VOCs waste gas is discharged together with the hot air; After the runner is transferred to the cooling area for cooling, the adsorption can be carried out again. With the continuous rotation of the runner, the adsorption, desorption and cooling cycles are carried out to ensure the continuous and stable operation of waste gas treatment.
Wood activated carbon Zhejiang Because the aluminum oxide tetrahedron of zeolite has a negative charge, and the skeleton hole contains cations, a strong electric field is formed around the cations. Therefore, the adsorption force of zeolite not only has a strong dispersion force, but also has a large electrostatic force. It is precisely because of this electrostatic relationship that zeolites have preferential selective adsorption on polar, unsaturated and polarizable molecules. It can strongly adsorb molecules containing polar groups such as hydroxyl ion, ammonium ion and other polarizable groups, especially water, which can form hydrogen bonds with aluminum silicon skeleton, so zeolite has strong water absorption. It can still adsorb even under low relative humidity and concentration, and its water absorption is higher than that of silica gel and activated alumina. The main material of honeycomb zeolite adsorbent is natural zeolite. The manufacturer of zeolite is composed of silica Inorganic microporous material composed of al_2o_3 and alkaline metal or alkaline earth metal, with inner pore volume accounting for 40-50% of the total volume and specific surface area of 100-500 m2/g, is characterized by high temperature resistance, non flammability, good thermal stability and hydrothermal stability. It is an efficient molecular sieve carrier with good adsorption performance, no secondary pollution, and can be regenerated at high temperature. Compared with honeycomb activated carbon, its performance is about 25% of its efficiency, However, it is widely used in the fields of adsorption, separation, catalysis and environment due to its high temperature resistance and difficult ignition. It is more suitable for the treatment of organic waste gas with large air volume and low concentration.
